| 1. Lift a back part of the car. |
| 2. Establish supports under a bridge beam. |
| 3. Disconnect from bars conducting of sensors of speed. |
|
4. For removal of the top bar unscrew nuts (are specified by shooters), remove washers and fastening bolts to a frame and to the bridge. |
| 5. For removal of the bottom bar unscrew nuts, remove washers and fastening bolts to arms on a frame and the bridge. |
| 6. Check a condition of plugs of bars. |
| 7. At detection of damages of the plug replace (replacement is carried out in car-care center). |
| 8. Installation of bars is carried out upside-down. |
| 9. Nuts of fastening of bars finally tighten after car lowering. |